Click To Call(727) 591-3365Click To Get A Free Estimate
Backyard paver patio with outdoor chairs and a table on a freshly sealed surface

A patio worth sitting on again

Patio Paver Sealing in St. Petersburg, FL

Call (727) 591-3365 for a free price to seal the patio pavers behind your house.

  • Brings out deeper paver color
  • Fresh joint sand helps lock pavers in place
  • Gives weeds less room to grow
  • Makes the surface easier to keep clean
  • Free estimate, no obligation

Request a Free Estimate

Free, no obligation.

Step 1 of 2

Where are your pavers?

Please choose one.

Free EstimateNo obligation
Fast ReplyWithin 1 business day, usually much sooner
Typical Local Price$1.25 to $2.50 a sq ft to clean, sand and seal
Call Now(727) 591-3365
Patios

Will someone seal my St. Petersburg patio pavers, and when do I hear back?

A local contractor can seal patio pavers at homes across St. Petersburg, FL, and replies land within one business day, frequently the same afternoon. The estimate is free and nothing obliges you to book. To start, call (727) 591-3365.

A patio is where chairs scrape, drinks spill, grills sit and the shade never quite dries. Sealing slows the algae, keeps the sand between the pavers and lets the surface rinse clean after a cookout. Say how big the patio is, whether it sits under an oak or a roof and where it stays damp, then request a free estimate.

Call (727) 591-3365

Pricing

How much does it cost to seal a paver patio in St. Petersburg?

Published patio figures

Rusty's Pro Wash and Seal lists a 250 square foot patio at $500 to $1,000 and says most companies set a minimum charge of $500 to $1,000. Washy Bear lists $1.50 to $2.50 per square foot. The table puts those figures in one place. For a number on your patio, request a free estimate.

Why small patios cost more per foot

Small patios cost more per foot because setup and travel are spread over fewer feet, and Rusty's says large jobs can approach $1.00. Shade, algae and joint sand loss add work, and Rusty's says surface condition, repairs and access change the final bid. Compare a bid with the table, then call (727) 591-3365 with questions.

Patio sizeAt $1.25 to $2.50 a sq ft (Rusty's Pro Wash and Seal)What else is published
250 sq ft$500 to $1,000Rusty's patio example; minimum charges run $500 to $1,000
400 sq ft$500 to $1,000Same range, multiplied by the size
600 sq ft$750 to $1,500Washy Bear lists $1.50 to $2.50 a sq ft

Rusty's Pro Wash and Seal lists the 250 square foot patio itself. The 400 and 600 square foot rows multiply its published rate by the size, so they are a guide and not a quote. Large jobs can approach $1.00 a foot, while small patios often meet the minimum charge.

Get a Free Estimate

Local conditions

What makes a St. Petersburg patio turn green, gray or stained?

Shade and humidity

Shade is the biggest factor. Paver Ink says heavy canopy grows algae that needs treatment, while full sun on the same lot fades color and needs it restored before sealing. Humid air makes it worse, since Wikipedia lists a rainy season from June through September and 52.48 inches of rain a year. For a patio under an oak, call (727) 591-3365.

Leaves, spills and salt

Tannins from leaves leave brown marks, and Premier Coatings recommends keeping leaves off pavers and cleaning sunscreen, oil or rust spills quickly. Salt and moisture in the air also penetrate unsealed pavers, according to the same company. Point out the stains you see when you request a free estimate.

Homeowner and contractor looking over a shaded backyard patio with a paver sample in hand

Which finish is better for a patio, wet look or natural?

Matte, satin and wet look

Washy Bear lists a water based clear coat with a natural matte look and a semi gloss wet look that deepens color. Premier Coatings adds satin with a soft sheen. Patios often sit in the shade, so a matte finish hides less and grips better, while a wet look suits a sunny sitting area. To see small samples, request a free estimate.

Grip and furniture

Unilock adds that gloss turns slippery when wet and matte is the safer choice. Where chairs sit and where the grill goes also matter. If you plan to move furniture around, mention it when you call (727) 591-3365.

How is a faded patio washed without hurting the pavers?

Washy Bear lists 1,500 to 2,500 PSI with a commercial rig for a deep wash on faded patio pavers, below the 3,000 to 4,000 used on driveway brick and above the 500 to 1,000 used on pool decks. Unilock warns that a hard stream washes out joint sand and suggests a fan nozzle about 12 inches away. Ask what pressure is planned when you request a free estimate.

Faded color is restored before sealing, according to Paver Ink, because sealer locks in what is there. A pale patio sealed as is stays pale. Ask what the wash is expected to bring back by calling (727) 591-3365.

How it works

What is the patio sealing process, one step at a time?

A patio is a smaller job than a driveway but follows the same order of work. Premier Coatings lists a deep clean, algaecide, a rinse, polymeric sand, masking and a flood coat, and Paver Ink says the coat goes on only when the stone is dry all the way through. The steps below show how that plays out on a shaded patio. To ask about timing, call (727) 591-3365.

1. Measure and map the shade

The contractor measures the patio and notes which corners stay damp, which fade in sun and where water stands.

2. Deep wash and algae treatment

A flat surface cleaner covers the patio evenly at a pressure picked for faded pavers, with algae treated first.

3. Let the stone dry through

Shaded patios can take about a day to dry, and sealer on damp pavers can turn cloudy.

4. Refill the joints

Polymeric sand is swept in, the extra is brushed off the face and the joints are misted so they set.

5. Seal in a wet look or matte

The coat goes on in one session so the gloss matches, then furniture waits until the contractor gives the all clear.

Does it matter how many coats go on a patio?

Contractors disagree. Paver Ink applies two coats on every job it describes, while Unilock says to seal in one session and to use a dry roller to remove excess so the finish stays even. Premier Coatings applies a heavy flood coat. A thin even coat beats a thick one, and the label rate is the guide. To ask how many coats a bid includes, request a free estimate.

How soon can I put the patio furniture back?

Washy Bear and Rusty's Pro Wash and Seal say about 24 hours before feet, and Unilock allows up to 48 dry hours for the cure. Furniture legs can mark a soft coat, so wait for the contractor to say it is ready. Keep sprinklers off meanwhile. To plan a patio dinner around the schedule, call (727) 591-3365.

Service area

Which St. Petersburg neighborhoods can get patio paver sealing?

Patio jobs run from fenced backyards to townhome courtyards. Pasadena mixes ranch homes, condos and townhomes, and its bay facing lots carry different flood zones than the interior lots. Shore Acres sits on low ground with canals, and about 80 percent of the homes in its ZIP code are single family. If your community has an HOA, check its color rules before choosing a finish. Contractors cover each place below, and request a free estimate.

Photos

What do sealed patio pavers look like in St. Petersburg backyards?

Freshly sealed paver driveway behind a house in the Sunshine City
Sealed paver pool deck behind a house in the Sunshine City
Sealed paver patio behind the home behind a house in the Sunshine City
Sealed paver walkway to a front door behind a house in the Sunshine City
Close view of freshly sealed pavers behind a house in the Sunshine City
Paver area with one cleaned half beside a dirty half behind a house in the Sunshine City
Contractor cleaning pavers behind a house in the Sunshine City
Contractor sealing or sanding pavers behind a house in the Sunshine City
Questions

What do St. Petersburg homeowners ask about patio paver sealing?

Is it better to spray or roll paver sealer?

Unilock lists a garden sprayer with an adjustable nozzle, a foam roller or a short pile roller, followed by a dry roller to remove extra product so streaks and drips do not set. Washy Bear sprays sealer evenly and checks coverage afterward. Tight patio corners are usually rolled by hand.

What should I clean pavers with before sealing?

The cleaner is matched to the stain. Washy Bear says flat surface cleaners lift dirt, algae and oil, and Premier Coatings uses an algaecide after the deep clean. Unilock says high pressure can wash joint sand out, so a fan nozzle about 12 inches away is used. Sealer goes on only after everything has dried.

How much does it cost to seal a paver patio in St. Petersburg?

Rusty's Pro Wash and Seal lists a 250 square foot patio at $500 to $1,000 and says most companies set a $500 to $1,000 minimum. Washy Bear lists $1.50 to $2.50 per square foot. A patio near 400 square feet falls inside the minimum band.

Is the water in St. Petersburg, Florida hard?

Waterhardness.org lists ZIP 33710 at 184 PPM, or 10.8 grains per gallon, which it calls very hard, though readings vary by utility and address. Hard water leaves mineral rings, and Premier Coatings advises aiming sprinkler heads away from pavers. Ask the contractor to look at white or brown rings near the beds before the patio is sealed.

How often should a paver patio be resealed?

Rusty's Pro Wash and Seal says 3 to 5 years, and Washy Bear and Premier Coatings say 2 to 3 in coastal Pinellas. A shaded, low traffic patio can reach the longer figure, while a sunny one near the water ages sooner. Check whether water still beads on it.

Does a covered or shaded patio need sealing too?

Often. Paver Ink says shaded lots grow algae, and Premier Coatings says unsealed pavers collect efflorescence and shifting joints in the humid Pinellas climate. A coat makes shaded stone easier to keep clean, though a covered patio may last at the long end of the reseal range.

Can a patio be sealed if the pavers still have algae?

No, not safely. Premier Coatings treats algae with an algaecide and rinses before sealing, and Paver Ink says algae from shade needs treatment and gentle cleaning. Sealing over growth locks it under the coat, so it is removed first.

What pressure is used on faded patio pavers?

Washy Bear lists 1,500 to 2,500 PSI for a deep wash and color seal on faded patio pavers, lower than the 3,000 to 4,000 used on a driveway and higher than the 500 to 1,000 on a pool deck. Pressure is matched to the pavers and not set at one number.

How long before the patio can be used after sealing?

Washy Bear and Rusty's Pro Wash and Seal say about 24 hours for feet, and furniture usually waits until the contractor says the coat has cured. Unilock says to allow up to 48 dry hours for the cure and to keep sprinklers off. Plan the cookout for a few days later.

Ready to enjoy the patio again?

Call or use the short form and a local contractor answers inside one business day, usually well before.

Call (727) 591-3365

Free, no obligation