
Deeper color and joints that stay put
Paver Sealing in St. Petersburg, FL
Call (727) 591-3365 for a free paver sealing price on your driveway, pool deck or walkway.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Who can seal my pavers in St. Petersburg, and how fast?
A local contractor can seal pavers anywhere in St. Petersburg, FL, and you will hear back within 1 business day, usually much sooner. The estimate is free, and booking is up to you. To begin, call (727) 591-3365.
Sealing deepens the color of pavers, holds the joint sand in place and makes dirt easier to rinse off. Picture the drive you pull onto each evening, gray at the edges and low at the seams, turned dark and even again with every joint full. A driveway carries tires and oil, while a pool deck carries splash and bare feet, so each area gets its own plan. Say how your family uses each one when you request a free estimate.
Paver Sealing St Petersburg Is Proud to Serve Tampa Bay

What is included in a paver sealing job in St. Petersburg?
A job has four parts: an inspection, a deep wash, new joint sand and the sealer coat. Rusty's Pro Wash and Seal lists the same order. Washing usually takes the longest. To walk through each part for your own property, call (727) 591-3365.
Inspection
The contractor notes size, low spots, cracked pavers, worn sealer, stains and places where water stands before naming a price.
Deep wash
Algae, oil and dirt come off with cleaners matched to each problem, then a flat surface cleaner covers the area evenly.
Joint sand
Polymeric sand fills each gap, which ties the pavers together and leaves weeds and ants less room.
Sealer coat
Sealer goes on only when the surface is dry, in even passes at the coverage the label calls for.
How can I tell my St. Petersburg pavers need sealing?
Look for faded color, joints that sit below the paver edges, sand spread across the drive after a storm and water that soaks in instead of beading. Green film in shaded corners and brown spots under live oaks are further signs. Adding sand while the gaps are shallow costs less than relaying pavers that have drifted. For a quick opinion, call (727) 591-3365.
Which sealer suits a St. Petersburg home?
No single product fits every house, so ask which sealer the contractor plans to use and why. Rusty's Pro Wash and Seal describes three finishes: natural, wet look and high gloss, with wet look the most requested around Tampa Bay. To compare options for your pavers, call (727) 591-3365.
Unilock says water based sealer is easier to clean up and hardens the joint sand, and that solvent based sealer gives a high shine and holds up in heavy traffic but needs pavers and joints that are perfectly dry. Solvent products also evaporate faster, so a cooler day suits them better. Ask which one goes where when you request a free estimate.
Wet look or natural finish: which should I pick?
Pick wet look for deeper color and shine, and pick a natural matte finish to stay close to how the pavers looked new. Unilock says a wet look deepens color while a penetrating matte keeps texture and traction, and that gloss can turn slippery when wet. Beside a screened pool, grip tends to matter more than gloss. To see samples of both, request a free estimate.
How often do St. Petersburg pavers need a new coat of sealer?
Most surfaces need a new coat every three to five years. Rusty's Pro Wash and Seal says a driveway in full sun often calls for attention near year three, a covered patio can last five or more and a pool deck wears faster from chemicals and moisture. Washy Bear, a Hillsborough County company, puts a driveway reseal at two to three years. Your schedule follows the sun and the traffic each area gets. To have your coat checked, call (727) 591-3365.
Do extra coats of sealer protect pavers longer?
No. Unilock says to seal in one session, because layers stacked on one spot cause uneven gloss, and it lists too much product as a cause of a whitish film. A thin, even coat at the label rate is the usual plan, so when a bid calls for three or four coats, ask what each one adds before you request a free estimate.
When should I seal pavers in St. Petersburg?
Plan around the forecast more than the calendar. Unilock asks for 24 to 48 hours of clear skies before and after, temperatures from about 50 to 90 degrees with 75 the sweet spot, and sprinklers turned off. Pavers heated by direct sun can stain or peel early. The June to September rainy season can push a date back a few days. Call (727) 591-3365 when you want a date lined up with the weather.
New pavers have to wait. Unilock says to hold off until the white salt haze called efflorescence is gone, which typically takes two to three months and can take up to a year, and it gives 60 to 90 days as the wait for new pavers. Installed pavers within the last few months? Give the install date when you request a free estimate.
Can sealing fix sunken or loose pavers?
No. Per Unilock, a coat of sealer does not repair drainage trouble or a weak subbase. Pavers that rock under a tire or sit in a puddle after rain need base work first, because joint sand only holds on a level surface. Find out if leveling is included or charged separately when you request a free estimate.
Which paved areas at a St. Petersburg home can be sealed?
A coat can go on a driveway, a pool deck, a courtyard or a front walk. Wear differs from area to area, so each gets a separate plan. To begin where the problem is worst, request a free estimate.
Driveways
Drives carry the weight of cars, leaked oil and long hours of sun. Sealing one keeps the color even and the joints full where the wheels run.
Pool decks and lanais
A pool deck sees splash, chemicals and bare feet, which wear a surface in a different way than a drive does. Sealing a pool deck should leave it with decent grip when wet.
Courtyards and patios
Courtyards and patios between a house and a fence stay damp and shaded. Sealing one starts with the greenest corners and the spots where water collects.
Walkways and entries
A front walk collects planter drips, mulch and soil from the beds beside it. Sealing an entry is a small job, yet it is the first thing a guest steps on.
What paver problems are common in St. Petersburg?
Five problems come up again and again in this part of Pinellas County: fading, lost joint sand, green growth, tannin and mineral spots and salt. Each one is cheaper to handle early. To learn which ones affect your pavers, call (727) 591-3365.
1. Fading under the Sunshine City sky
The city averages about 361 days of sunshine a year, according to Wikipedia, and Rusty's Pro Wash and Seal lists UV exposure as a steady cause of paver fading. A driveway with no shade loses color first.
2. Joint sand lost in the rainy season
Wikipedia describes a rainy season from June through September and about 52 inches of rain a year. Rusty's Pro Wash and Seal says heavy summer rain saturates pavers and erodes the sand between them, so sand goes back in before any sealer.
3. Green growth in damp, shaded spots
Humid air feeds mold, mildew and algae, and Rusty's Pro Wash and Seal points to pool decks, shade and poorly drained areas. A coat of sealer over that growth can trap it, so it is washed off first.
4. Brown tannin and mineral spots
Rusty's Pro Wash and Seal says live oak tannins soak into pavers that are unsealed or under sealed, and that hard water from irrigation leaves mineral deposits. Those marks get treated before a coat goes down.
5. Salt from the air and from the pool
The city has water on three sides, and Rusty's Pro Wash and Seal lists salt air as a load on coastal pavers. It also says a saltwater pool speeds up efflorescence, the white salt film, and can shorten sealer life on the deck.
What does paver sealing cost in St. Petersburg?
Expect about $1.25 to $2.50 per square foot for the clean, sand and seal together, the range Rusty's Pro Wash and Seal publishes for Tampa Bay. A Hillsborough County company, Washy Bear, lists $1.50 to $2.50. Rusty's also says surface condition moves the price more than paver material does. For a number written for your home, request a free estimate.
Size matters in two directions. Rusty's gives a 2,500 square foot job at $3,125 as $1.25 a foot, and a 250 square foot patio at $750 as $3.00, because setup and travel spread over fewer feet. Small jobs often meet a minimum charge of $500 to $1,000. If a quote looks far lower than these figures, ask which steps it leaves out. With a bid in hand, call (727) 591-3365 and compare.
Looking only for a wash? The paver cleaning and joint sand page covers that, and the service area list shows which places contractors cover. The home page carries the estimate form.
| Paved area | Typical example | Clean, sand and seal |
|---|---|---|
| 300 sq ft | Small patio or walkway | $375 to $750 |
| 600 sq ft | Two car driveway | $750 to $1,500 |
| 1,000 sq ft | Large driveway or pool deck | $1,250 to $2,500 |
| 1,500 sq ft | Driveway plus pool deck | $1,875 to $3,750 |
Math based on the $1.25 to $2.50 per square foot that Tampa Bay paver companies publish. Your contractor sets the actual price after seeing the surface. Repairs, leveling and stripping failed sealer are usually extra.

Why hire a contractor who works near St. Petersburg?
A contractor who works around the city already plans for summer downpours, salt air and tight lots. The price comes to you in writing, and the final say is yours. To begin, call (727) 591-3365.
A contractor who works in the city
A local company already knows the lot sizes, the bay breezes and the summer downpours here. Your first visit then starts from local know-how instead of guesswork.
A free look and a free price
Looking at your pavers and writing the estimate costs you nothing. If the price does not suit you, say no and that is the end of it.
Tampa Bay prices to measure against
Paver companies around Tampa Bay publish what they charge per square foot, and this site passes those figures along. A bid that lands far from them is worth questioning.
Your pace, your decision
Get the figure on paper and give yourself time to think. The contractor standards page covers what to ask before you accept a bid.
Ready for a free paver sealing estimate in St. Petersburg?
Call or use the short form, and an answer arrives within 1 business day, often well before.
Free, no obligation

How do St. Petersburg pavers look after a fresh seal?








How does the paver sealing process work from start to finish?
Nearly every job follows the same five steps, from the first inspection to a walk through at the end. If you are ready to schedule, call (727) 591-3365.
1. Measure and inspect
Before pricing the sealing job, the contractor measures the area and notes cracked or sunken pavers, old sealer, stains and any spot where water stands.
2. Protect and wash
Plants are wetted down and screen panels covered. A flat surface cleaner then washes the pavers evenly, which is gentler on the joints than a bare wand.
3. Treat what is left
Algae gets a biocide, oil gets a degreaser and rust gets its own treatment. White salt film is handled with a cleaner made for it, and each is tried on a small spot first.
4. Refill the joints
Once the pavers dry, polymeric sand is swept in and misted, as ICPI standards describe, so it hardens. Extra sand is brushed off the surface.
5. Seal and walk it with you
If sealer is on the work order, it goes on a dry surface with a sprayer and a roller. The contractor then shows you the finished area and says when feet and tires can return.
Frequently Asked Questions
What is the average cost to seal pavers in Florida?
Around Tampa Bay, companies publish $1.25 to $2.50 per square foot to clean, sand and seal, and one Hillsborough County company lists $1.50 to $2.50. A 1,000 square foot St. Petersburg driveway comes to about $1,250 to $2,500 at the published rate. Fixing pavers or stripping a failed coat adds to the bill.
What are the downsides of sealing pavers?
The main one is the repeat cost, since a coat lasts roughly three to five years. Unilock lists three more limits: sealing does not cure poor drainage or a weak base, gloss can be slippery when wet, and too much product can leave a whitish film.
Is it better to spray or roll paver sealer?
Many contractors use both. Unilock lists a garden sprayer with an adjustable nozzle, a foam roller or a short pile roller, plus a dry roller to soak up extra product so streaks and drips do not set. An even coat matters more than the tool.
What do professionals use to seal pavers?
A water based or solvent based sealer, put down with a sprayer and a roller. Unilock says water based products are easier to clean up and harden the joint sand, while solvent based products give a higher shine but need pavers and joints that are perfectly dry.
How often should I seal pavers in Florida?
Plan on every three to five years, which is what both Unilock and Rusty's Pro Wash and Seal say. A sunny driveway can ask for attention near year three, and a covered patio can go five or more. Washy Bear, a Hillsborough County company, puts a driveway reseal at two to three years.
Does salt air from Tampa Bay shorten sealer life?
It can add wear. Rusty's Pro Wash and Seal lists salt air as a load on coastal pavers and says Gulf front homes tend to need resealing sooner than inland homes. Pavers a few blocks from the water usually sit between the two.
How long should I stay off pavers after sealing in St. Petersburg?
Plan on about a day for feet and two to three days for cars. Rusty's Pro Wash and Seal says foot traffic is fine after about 24 hours and vehicles need 48 to 72. Unilock asks for the sprinklers to stay off while the coat cures.
Does the summer rainy season change when pavers get sealed?
Yes, because sealer needs dry weather. Wikipedia lists a rainy season from June through September, and Unilock asks for clear skies for 24 to 48 hours before and after sealing. A contractor watches the forecast and moves the date when a storm is near.
Can pavers around a St. Petersburg pool be sealed?
Yes, and many are. Unilock says a high gloss can be slippery when wet, so ask for a finish with good grip. Rusty's Pro Wash and Seal says a saltwater pool speeds up efflorescence, which is worth mentioning when you ask for a price.
Time to protect your St. Petersburg pavers?
Send a short request or call, and a contractor writes back within 1 business day, often within hours.
Free, no obligation
